How to set up a gateway/router using Raspberry Pi 4G/LTE Cellular Modem Kit

[gokul_gj]

Hi Team,

I wanted to design a router using Raspberry Pi & 3G-4G/LTE Base Shield V2.
Internet from WWAN0 and LAN connection through ethernet port.
WWAN0-------Rasp PI ethernet-------LAN Network switch----Internet for devices connected on Network switch.

DO any one have the document to do the above setup.

Best Regards,
Gokulan

[Steve]

Hello,
I have a similar interest and wanted to see if you found a solution here.

[ensar]

Hi,

A similar topic:

QMI How to share wwan0 with eth0

Hello every body. I just reinstall my Raspberry Pi with the 3G/4G & LTE Base HAT and it works well. I need to connect a second Raspberry to the ethernet port and both must have access to internet throught the wwan0. Specially the second Raspberry must have access to internet through the first which has the 4G HAT. Addtionnaly, on the first PI, I configured it as a hotspot following that procedure but it look not the best because it show how to share wlan0 with eth0. I also read this very use…

Hope it helps you.